Bikeway Lessons From Medford, Oregon

The week of Thanksgiving, I visited relatives in Medford, Oregon. Many readers might expect that all of blue-state Oregon would be as bike-friendly as its big cities, Portland and Eugene, but this is not the case. Oregon’s eighth largest city (population 86,000) is relatively car-centric. Medford has a pleasant but struggling historic downtown, which is surrounded by lots of suburban development. People certainly bike and walk, but the city is mostly conducive to getting around by car.

I don’t claim to be an expert on Medford, though I have visited a couple of times. This year, I checked out some green transportation features and figured I would share them with SBCA readers.

Medford’s new parking-protected two-way bikeway on Main Street

This year, Medford added what I think are the city’s first protected bike lanes. Through downtown, the city removed one car lane (which generated some criticism) to make space for adding a two-way parking-protected bikeway. The facility runs about 0.6 miles on Main Street between Oakdale Avenue and 8th Street, where cyclists can connect with a bike path along Bear Creek.

The bikeway is the main part of a project the city termed Main Street Multimodal Improvements. I found it to be a fairly high-quality low-cost ($450,000 budget per The Rogue Valley Times) bike facility that could be a good example for other locations, especially for cities looking to improve bike and walk safety on central one-way streets.

Often, two-way protected bikeway projects feature costly bike traffic signals. Medford was largely able to omit these, instead installing signs for contraflow cyclists to simply “use ped signal.” (As far as I could tell, there is just one bike signal at Oakdale, the west end of the project.)

Bike signage facing contraflow cyclists. Instead of costly bike signals, cyclists are directed to use the pedestrian signal.

At unsignalized locations where drivers can turn left across the bikeway, signage clarifies that drivers are to stop for people on foot or bike.

Medford’s Main Street bikeway is nearly entirely parking-protected (parked cars separate cyclists from moving cars). To help drivers navigate properly, the facility includes plastic bollards, plastic speedbumps, and plastic curb-stops, as well as intermittent green pavement at driveways and intersections.

Main Street in Medford.

At the east end of the bikeway, the city installed a small bike traffic circle. It’s located at the Y-intersection where two-way Main Street splits into two one-way streets (Main and 8th) through downtown. At that location, westbound cyclists need to transition from a basic right-side bike lane onto the new protected bikeway on the left side of the street.

City of Medford design for traffic circle area – via design plans document

Medford’s bicycle traffic circle – located at the Y-intersection of Main Street and 8th Street, just east of Bear Creek. The westbound cyclist (middle left) is bypassing the circle.

The center of the bike traffic circle is emblazoned with the Medford city logo.

Medford’s bike traffic circle area is very well-lit, enhancing safety for cyclists and pedestrians at a point of conflict with drivers.

The circle works as sort of transition point, where cyclists get on or off the protected bikeway, continuing onto streets or the creek path. It’s a point where there could be bike-car conflict. For safety, it’s very well-lit and has curbs and pavement markings that specify where drivers, cyclists, and pedestrians go.

It isn’t perfect. During my visit, I observed 4-5 cyclists choosing to avoid the circle, biking around it instead of through it. At the time, car traffic there wasn’t heavy, so cyclists were taking a more direct, less curvy route than using the circle. This maneuver is perhaps a bit more dangerous, but makes sense (it’s faster, and conserves momentum/energy) when there aren’t a lot of cars to navigate around. The circle probably makes more sense at times when car (or bike) volumes are higher.

At the east end of the Main Street bikeway, cyclists can transition to the bike path along Bear Creek (parts of which are in the shadow of the 5 Freeway).

I also rode a Rogue Valley Transportation Authority bus for the first time. RVTA buses have an on-board monitor displaying quite a bit of real-time information: upcoming stops, the overall route, the local area, and also announcing stops – cycling through this in Spanish and English. It’s perhaps not essential (many riders can and do get this on their smart phones), but I found it informative and helpful, especially as someone not all that familiar with the area.

RVTA onboard display showing entire bus route and current location.

Bus monitor also shows upcoming stops.

Lastly, here’s one pedestrian facility: an emotionally intelligent crosswalk installation leading to a park, downtown library, and children’s museum.

The post New Two-Way Protected Bikeway in Medford, Oregon appeared first on Streetsblog California.

source https://cal.streetsblog.org/2023/11/29/new-two-way-protected-bikeway-in-medford-oregon